Dwyer PUX - Manual (Page 57)

9 - 16
9.3.3 SYSTEM OF UNITS: when setting the measurement and set-
ting unit system [selection of meter sys-
tem and inch system]
[Operation]
q Select “SYSTEM OF UNITS” by the or
key on the SYSTEM SETUP page. Press the
ENT key, and the SYSTEM OF UNITS screen
is displayed, prompting you to select units of
either meter system or inch system.
w Select “METRIC” or “INCH” by the
or key and press the ENT key.
The setting contents in the memory range are available in metric and inch systems. If you switch the unit
system, the memory range is switched accordingly, where different setting contents are displayed.
Select any of them according to your setting.
CAUTION
STOP BIT
COMMUNICATION
SYSTEM SETUP SYSTEM SETUP
CLOCK SET 95-06-25 15 : 17 : 00
PARITY
BAUD RATE
SYSTEMSETUP
1 BIT
NONE
300
METRIC
MEASUREMENT METHOD
MEMORY INITIALIZE
1
w
STOP BIT
COMMUNICATION
SYSTEM SETUP
CLOCK SET 95-06-25 15 : 17 : 00
PARITY
BAUD RATE
SYSTEMSETUP
1 BIT
NONE
300
METRIC
MEASUREMENT METHOD
MEMORY INITIALIZE
1
SYSTEM OF UNITS
SYSTEM OF UNITS SYSTEM OF UNITS
METRIC
INCH
BULLETIN F-68