Dwyer PUX - Manual (Page 74)

9 - 33
9.6 System check function (SYSTEM CHECK page)
This function allows you to check the condition of this instrument. If an error occurs, take countermeasures accord-
ing to chapter 11, “ERROR AND REMEDY”.
9.6.1 ERROR CHECK
When an error is detected on MEASURE screen
q Move the cursor to “ERROR CHECK” on the
SYSTEM CHECK page and press the
ENT key.
The ERROR CHECK screen is displayed.
w Select error items displayed on the MEASURE
screen by pressing the
or key.
e Press the ENT key, and the countermeasure
against error screen is displayed.
ERROR CHECK
SYSTEM CHECK SYSTEM CHECK
SIGNAL CHECK
SYSTEM CHECKSYSTEM CHECK
OUTPUT CHECK OUTPUT CHECK 75.00%
VER. NO.
ERROR CHECK ERROR CHECK
SYSTEM CHECK SYSTEM CHECK
SIGNAL CHECK
SYSTEM CHECK
OUTPUT CHECK
VER. NO.
SYSTEM CHECK SYSTEM CHECK
SYSTEM CHECK
0.00% 0.00%
ERROR CHECK ERROR CHECK
CALCULATION ERROR
MEASURING MODULE FAULT
PRINTER FAIL
RECEIVED SIGNAL ERROR
WINDOW SCANNING
TOO STRONG RECEIVED SIGNAL
NO RECEIVED SIGNAL
ANALOG OUTPUT ERROR
BACKUP BATTERY FAIL
INSIDE COMMUNICATION FAIL INSIDE COMMUNICATION FAIL
SYSTEM CHECK SYSTEM CHECK
SYSTEM CHECK
INSIDE COMMUNICATION FAIL INSIDE COMMUNICATION FAIL
Inside communication be-
tween modules has failed, so
measurements are impossible.
Turn the power off and on!
When the function will not
recover,contact the factory
BULLETIN F-68