Dwyer PUX - Manual (Page 46)

9 - 5
9.1.5 CUT OFF: output cut off at low flow rate
(low flow cutoff function)
When flow rate is extremely low, its output can be
cut off. (range: 0 to 1.000 m/s)
If fluid in the pipe is moving due to convection, etc.,
even though the valve is closed, this flowmeter
outputs a measured value. Therefore, values below
an appropriate level should be cut off.
0.010m/s Flow velocity - 0.010m/s
Output
[Operation]
q Press the or key on the SITE SETUP page
and select CUT OFF. Then, press the ENT key,
and the cursor moves to the set item. Output cut
off point is settable.
w Move the digit by pressing the or key and
enter a numeric value by pressing the or
key.
After entry, press the ENT key.
SITE SETUP
SITE SETUP SITE SETUP
PIPE PARAMETER
ZERO ADJUST
RESPONSE SET
CALIBRATION
TOTALIZE
MANUAL ZERO
0 s e c
--- SENSOR SPACING ---
0.0mm
PARAMETER MEMORY
CUT OFF 0.0 0 0 m/ s
BULLETIN F-68