Dwyer PUX - Manual (Page 18)

6 - 1
Before installing the detector, set the specifications of a pipe in the main unit to allow measurements.
Caution) Measurements cannot be accomplished without these settings.
6.1 Display of pipe setup screen
q Press the key on the “MEASURE” screen
to invert the “Tab”.
w Press the key, and the “SITE SETUP”
menu screen is displayed.
To move the cursor on the screen, press the
key or ENT key.
To invert “PIPE PARAMETER” on the menu
screen , press the
key on the “SITE
SETUP” screen.
e Press the ENT key, and “PIPE
PARAMETER” screen is displayed.
6. INPUT OF PIPING SPECIFICATIONS
x10
x10
RESET
STOP
STOP
RESET
FLOW RATE UNIT: m3/h
VELOCITY UNIT: m/s
+ TOTAL UNIT: ml
– TOTAL UNIT: ml
Title of page
95-06-27 11:49
MEASURE
SITE SETUP SITE SETUP
96-06-24 10:57
SITE SETUP
OUTER DIAMETER
PIPE MATERIAL
WALL THICKNESS
LINING MATERIAL
KIND OF FLUID
SENSOR MOUNTING
CARBON STEEL
0.01 m m
PIPE PARAMETER PIPE PARAMETER
13.00 m m
NO LINING
V
PSX2 B SENSOR TYPE
LINING THICKNESS 0.01mm
WATER
SITE NAME SITE NAME
X 1 TRANS, VOLTAGE
PIPE
PARAMETER
screen is
displayed.
95-06-27 14:49
SITE SETUP
SITE SETUP SITE SETUP
PARAMETER MEMORY
PIPE PARAMETER
ZERO ADJUST
RESPONSE SET
CALIBRATION
CUT OFF
TOTALIZE
MANUAL ZERO
0 s e c
0 . 0 0 0 m / s
--- SENSOR SPACING ---
125.7mm
Invert the
PIPE
PARAMETER
BULLETIN F-68