KROHNE MFC 300 EN - Manual (Page 95)

OPERATION
6
95
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
C6.6.6 GDC IR Interface After this function has been activated an optical GDC adapter can be
connected to the LC display. If approximately 60 seconds pass without a
connection being established or after the adapter is removed, then the
function is exited and the optical keys are active once again.
Break (exit function without connection)
Activate (the IR interface adapter and interrupt the optical keys)
If approximately 60 seconds pass without a connection being established,
then the function is exited and the optical keys are active once again.
C6.7 Units
C6.7 Units
C6.7.1 Volume Flow m³/h; m³/min; m³/s; l/h; l/min; l/s (l = litres); IG/s; IG/min; IG/h
ft³/h; ft³/min; ft³/s; gal/h; gal/min; gal/s; barrel/h; barrel/day
free unit (set factor and text in the next two functions, sequence see below)
C6.7.2 Text free unit For text to be specified refer to Set free units on page 96:
C6.7.3 [m³/s]*factor Specification of the conversion factor, based on m³/s:
xxx.xxx refer to Set free units on page 96
C6.7.4 Mass Flow kg/s; kg/min; kg/h; t/min; t/h; g/s; g/min; g/h;
lb/s; lb/min; lb/h; ST/min; ST/h (ST = Short Ton); LT/h (LT = Long Ton);
free unit (set factor and text in the next two functions, sequence see below)
C6.7.5 Text free unit For text to be specified refer to Set free units on page 96:
C6.7.6 [kg/s]*factor Specification of the conversion factor, based on kg/s:
xxx.xxx refer to Set free units on page 96
C6.7.7 Velocity m/s; ft/s
C6.7.9 Temperature ° C; K; °F
C6.7.10 volume m³; l (litres); hl; ml; gal; IG; in³; ft³; yd³; barrel
free unit (set factor and text in the next two functions, sequence see below)
C6.7.11 Text free unit For text to be specified refer to Set free units on page 96:
C6.7.12 [m³]*factor Specification of the conversion factor, based on m³:
xxx.xxx refer to Set free units on page 96
C6.7.13 Mass kg; t; mg; g; lb; ST; LT; oz;
free unit (set factor and text in the next two functions, sequence see below)
C6.7.14 Text free unit For text to be specified refer to Set free units on page 96:
C6.7.15 [kg]*factor Specification of the conversion factor, based on kg:
xxx.xxx refer to Set free units on page 96
C6.7.16 Density kg/l; kg/m³; lb/ft³; lb/gal; SG
free unit (set factor and text in the next two functions, sequence see below)
C6.7.17 Text free unit For text to be specified refer to Set free units on page 96:
C6.7.18 [kg/m³]*factor Specification of the conversion factor, based on kg/m³:
xxx.xxx refer to Set free units on page 96
C6.7.19 Pressure Pa; kPa; bar; mbar; psi (no free units possible);
only if current input available.
.book Page 95 Monday, February 6, 2012 11:01 AM