KROHNE MFC 300 EN - Manual (Page 175)

DESCRIPTION OF HART INTERFACE
9
175
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
Menu View
Calibration Calibration Cust
Density Calib. Opt <1 Pt. Dens. Cal.> Cust
<2 Pt. Dens. Cal> Cust
Cust
Cust
HART Preambles Request Preams Rd / Response Preams
Dynamic Variables Settings PV is Rd / SV is / TV is / 4V is
Parameter Protection Access Level HART
Display Values Volume Flow / Mass Flow / Flow Velocity / Temperature / Density / Device Status
Concentration Values Concentration 1 Opt / Concentration 2 or Diagnosis 3 Opt / Concentration Flow 1 Opt /
Concentration Flow 2 Opt
Diagnosis Values Diagnosis 1 Opt / Diagnosis 2 Opt / Concentration 2 or Diagnosis 3 Opt
Totaliser Totaliser 1 (B) Opt / Totaliser 1 (C) Opt / Totaliser 2 (D) Opt / Totaliser 3 (A) Opt
Yt diagram Mass Flow / Temperature / Density
Outputs Current Output/Frequency Output A Opt Measured Value Opt /
A Opt /
% Range A Opt
Current Output/Frequency Output B Opt Measured Value Opt /
B Opt /
% Range B Opt
Current Output C Opt Measured Value Opt /
C Opt /
% Range C Opt
Frequency Output D Opt Measured Value Opt /
D Opt /
% Range D Opt
Actual Values Operating Hours / Mass Flow / Volume Flow /
Velocity / Density / Temperature / Strain MT /
Strain IC / MT Frequency / Drive Level /
Sensor A Level / Sensor B Level / 2 Phase Signal /
SE PCB Temperature / BE PCB Temperature / Act. Operat. Mode
.book Page 175 Monday, February 6, 2012 11:01 AM