KROHNE MFC 300 EN - Manual (Page 170)

9
DESCRIPTION OF HART INTERFACE
170
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
Scan Device
Calibration Management
Diagnostics and Test
Simulation Mass Flow Cust / Simulation Density Cust / Simulation Temperature Cust /
Simulation A Opt / Simulation B Opt / Simulation C Opt / Simulation D Opt /
PCB Information / SE Serial No.
Calibrate
Zero Calibration Cust / D/A Trim Cust / Apply Values Cust /
Density Calib. Failed 1 Pt. Dens. Cal. Cust / 2 Pt. Dens. Cal. Cust /
Manual Dens. Cal. Cust / Standard Dens. Cal. Cust
Set / Reset
Reset Error / Reset Configuration Change Flag / Master Reset / Warmstart /
Reset Totaliser 1
Opt, Cust / Set Totaliser 1 Opt, Cust / Stop Totaliser 1 Opt, Cust /
Start Totaliser 1 Opt, Cust / Reset Totaliser 2 Opt, Cust / Set Totaliser 2 Opt, Cust /
Stop Totaliser 2 Opt, Cust / Start Totaliser 2 Opt, Cust / Reset Totaliser 3 Opt, Cust /
Set Totaliser 3 Opt, Cust / Stop Totaliser 3 Opt, Cust / Start Totaliser 3 Opt, Cust
Basic Configuration
Select Measurement Totaliser 1 / Select Measurement Totaliser 2 /
Select Measurement Totaliser 3
Opt / Select Diagnosis 1 /
Select Diagnosis 2 / Select Diagnosis 3 Opt /
Select Concentration Mode 1 Opt / Select Concentration Mode 2 Opt
Parameter Protection
Allow Service Access / Lock Service Access
Service
MUX Mode Opt / Temp. Password Opt / Read GDC Object Opt / Write GDC Object Opt
Rename
Unassign
Assign / Replace
Audit Trail
Record Manual Event
Drawings / Notes
Help…
.book Page 170 Monday, February 6, 2012 11:01 AM