KROHNE MFC 300 EN - Manual (Page 168)

9
DESCRIPTION OF HART INTERFACE
168
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
HART Identification Manufacturer Rd / Model Rd / Device ID Rd /
Address / Tag / Date / Message / Description /
Write Protect
Rd / Final Assembly No. / Sensor Serial No.
Revision Numbers Universal Rev. Rd / Device Rev. Rd /
Software Rev. Rd / Hardware Rev. Rd
Preambles Request Preams Rd / Response Preams
Dynamic Variables PV is Rd / SV is / TV is / 4V is
HART units Units Volume Flow / Mass Flow /
Flow Velocity / Conductivity /
Temperature / Totaliser 1 / Totaliser 2 /
Totaliser 3
Opt / Concentration 1 Opt /
Concentration 2 or Diagnosis 3 Opt /
Concentration Flow 1 Opt / Concentration Flow 2 Opt /
Diagnosis 1 Opt / Diagnosis 2 Opt
HART Format Display Formats Volume Flow Loc / Mass Flow Loc /
Flow Velocity Loc / Density Loc /
Temperature Loc / Totaliser 1 Loc / Totaliser 2 Loc /
Totaliser 3 Opt, Loc / Concentration 1 Loc /
Concentration 2 or Diagnosis 3 Loc /
Concentration Flow 1 Loc / Concentration Flow 2 Loc /
Diagnosis 1 Loc / Diagnosis 2 Loc
Service Access Level HART Rd
Compare and Clear Offline
Status / Conditions
Overview Standard Primary variable out of limits
Non-primary variable out of limits
Primary variable analog output saturated
Primary variable analog output fixed
Field Device Cold Start
Malfunction
Configuration changed
Failure (device) F Device Error / F IO1 / F Parameter / F IO2 / F Configuration / F Display /
F Sensor: Global Data Error / Sensor: Local Data Error / F SE Data Error /
F SE Drive Failure / F SE Hardware Failure / F SE Data Different /
F SE Defective / F Interface PCB Failure / F SE Wiring Error /
F 2 Phase Flow / F Fieldbus /
F Current Output A / F Current Output B / F Current Output C /
F SW User Interface / F Hardware Settings / F Hardware Detection /
F RAM/ROM Error IO1 / F RAM/ROM Error IO2
Failure (application) F Application Error / F Tube Not Oscillating / F System Control /
F Open Circuit A / F Open Circuit B / F Open Circuit C /
F Wiring A / F Wiring B / F Sensor: Under Range /
F Stop Mode / F Sensor: System Error / F SE Comms. Failure /
F Over Range A (Current) / F Over Range B (Current) / F Over Range C /
F Over Range A (Pulse) / F Over Range B (Pulse) / F Over Range D /
F Active Settings / F Factory Settings / F Backup 1 Settings /
F Backup 2 Settings
.book Page 168 Monday, February 6, 2012 11:01 AM