KROHNE MFC 300 EN - Manual (Page 81)

OPERATION
6
81
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
6.4.2 Menu B, Test
No. Function Settings / descriptions
B1 Simulation
B1 Simulation Displayed values are simulated.
B1.1 Mass Flow Simulation of mass flow
Set value (range and units depend on measurement)
break (exit function without simulation)
Query: start simulation?
Settings: no (exit function without simulation) / yes (start simulation)
B1.2 Density Sequence and settings similar to B1.1, see above!
X stands for one of the connection terminals A, B, C or D
stands for Fct. B1.4...1.7
B1.3 Temperature
B1. Current Output X Simulation X
X stands for one of the connection terminals A, B, C or D
Sequence and settings similar to B1.1, see above!
For pulse output a set number of pulses are output in 1 s!
B1. Pulse Output X
B1. Frequency Output X
B1. Control Input X
B1. Limit Switch X
B1. Status Output X
B2 Actual Values
B2 Actual Values Display of current values;
Exit the displayed function by pressing the ^ key.
B2.1 Operating Hours Device operating hours
B2.2 Mass Flow Current unfiltered mass flow
B2.3 Volume flow Current unfiltered volume flow
B2.4 Velocity Current unfiltered flow velocity
B2.5 Density Current unfiltered density
B2.6 Temperature Current unfiltered temperature
B2.7 Strain MT Current value for the measuring tube strain
B2.8 Strain IC Current value for the inner cylinder strain
B2.9 Tube Frequency Current vibration frequency of the measuring tube
B2.10 Drive Level Current drive level to activate vibration
B2.11 Sensor A Level Current vibration amplitude
B2.12 Sensor B Level
B2.13 2 Phase Signal 2 phase indicator value
B2.14 SE PCB Temperature Temperature of sensor electronics
B2.15 BE PCB Temperature Temperature of signal converter
B2.16 Act. Operat. Mode Current operating mode
.book Page 81 Monday, February 6, 2012 11:01 AM