KROHNE MFC 300 EN - Manual (Page 26)

4
ELECTRICAL CONNECTIONS
26
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
Electrical connections
4.1 Safety instructions
4.2 Important notes on electrical connection
DANGER!
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
DANGER!
Observe the national regulations for electrical installations!
DANGER!
For devices used in hazardous areas, additional safety notes apply; please refer to the Ex
documentation.
WARNING!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
DANGER!
Electrical connection is carried out in conformity with the VDE 0100 directive "Regulations for
electrical power installations with line voltages up to 1000 V" or equivalent national regulations.
CAUTION!
•
Use suitable cable entries for the various electrical cables.
• The measuring sensor and signal converter have been configured together at the factory. For
this reason, please connect the devices in pairs.
.book Page 26 Monday, February 6, 2012 11:01 AM