KROHNE MFC 300 EN - Manual (Page 169)

DESCRIPTION OF HART INTERFACE
9
169
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
Out of specification S Out Of Specification / S Tube Asymmetry / S System Control /
S Startup / S Power Fail / S 2 Phase Flow /
S Excessive Noise / S External Vibration / S Sensor Levels /
S Res. Circ. Defective / S SE Defective / S Interface PCB Failure /
S Density / S Density Calib. Failed / S Sensor Signal Error /
S Temperature Drift / S BE PCB Temperature / S SE PCB Temperature /
S Tube Temperature / S Overflow Totaliser 1 / S Overflow Totaliser 2 /
S Overflow Totaliser 3 / S Backplane Invalid
Check request &
Information
Check request C Checks In Progress / C Sensor Electronics /
C Standby Mode / C Zero Calibration
Information I Totaliser 1 Stopped/ I Totaliser 2 Stopped /
I Totaliser 3 Stopped / I Power Fail /
I Control Input A act. / I Control Input B act. /
I Over Range Display 1 / I Over Range Display 2 /
I Backplane Sensor / I Backplane Settings /
I Backplane Difference / I Optical Interface
Actual Values & Self Test Operating Hours / Mass Flow / Volume Flow /
Velocity / Density / Temperature / Strain MT /
Strain IC / MT Frequency / Drive Level /
Sensor A Level / Sensor B Level / 2 Phase Signal /
SE PCB Temperature / BE PCB Temperature / Act. Operat. Mode
Max. Rec. Temp. / Min. Rec. Temp.
Information (Service)
Process Variables
Process Values Volume Flow / Mass Flow / Flow Velocity / Density / Tube Temperature
Concentration / Diagnosis Diagnosis 1 Opt / Diagnosis 2 Opt / Concentration 1 Opt /
Concentration 2 or Diagnosis 3 Opt / Concentration Flow 1 Opt / Concentration Flow 2 Opt
Totaliser Totaliser 1 Opt / Totaliser 2 Opt / Totaliser 3 Opt
Outputs A Opt / % Range A Opt / B Opt / % Range B Opt / C Opt / % Range C Opt /
D Opt / % Range D Opt
Device Tag Rd / Description Rd
HART Polling address Rd / Device ID Rd
.book Page 169 Monday, February 6, 2012 11:01 AM