KROHNE MFC 300 EN - Manual (Page 94)

6
OPERATION
94
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
C6. .10 3rd Line Variable Specify 3rd Line Variable (only available if this 3rd line is activated)
Select: Volume Flow / Mass Flow / Temperature / Density / Velocity /
Totaliser 1 / Totaliser 2 / Totaliser 3 / Operating Hours / Diagnosis 1 /
Diagnosis 2
Depending on the settings for the concentration measurement, the following
measurements are possible:
Diagnosis 3 / Concentration 1 / Concentration 2 / Concentration Flow 1 /
Concentration Flow 2
C6. .11 3rd Line Format Specify decimal places.
Select: automatic (adaptation is automatic) /
X (= none) …X.XXXXXXXX (max. 8 digits) depends on size of font
C6.5 Graphic Page
C6.5 Graphic Page
C6.5.1 Select Range Graphic page always shows trend curve of the measurement of the 1st page
/ 1st line, see Fct. C6.3.2
Select: Manual (set range in Fct. C6.5.2) /
Automatic (automatic depiction based on the measured values)
Reset only after parameter change or after switching off and on.
C6.5.2 Range Set the scaling for the Y axis. Only available if "manual" is set in C6.5.1.
+xxx ±xxx%; range: -100…+100%
(1st value = lower limit / 2nd value = upper limit),
condition: 1st value ≤ 2nd value
C6.5.3 Time Scale Set the time scaling for the X axis, trend curve
xxx min; range: 0…100 min
C6.6 Special Functions
C6.6 Special Functions
C6.6.1 Reset Errors Reset Errors?
Select: no/yes
C6.6.2 Save Settings Save current settings.
Select: cancel (exit function without saving) / backup 1 (save in storage
location 1) / backup 2 (save in storage location 2).
Query: continue copy? (cannot be done afterwards)
Select: no (exit function without saving) / yes (copy current settings to
storage backup 1 or backup 2)
C6.6.3 Load Settings Load saved settings.
Select: break (exit function without loading) / factory settings (load in state
as delivered) / backup 1 (load data from storage location 1) / backup 2 (load
data from storage location 2)
Query: continue copy? (cannot be done afterwards)
Select: no (exit the function without saving) / yes (load data from the selected
storage location)
C6.6.4 Password Quick Set Password required to change data in the quick setup menu.
0000 (= to Quick Setup menu without password)
xxxx (password required); range 4 digits: 0001…9999
C6.6.5 Password Setup Password required to change data in the setup menu
0000 (= to Quick Setup menu without password)
xxxx (password required); range 4 digits: 0001…9999
.book Page 94 Monday, February 6, 2012 11:01 AM