KROHNE MFC 300 EN - Manual (Page 176)

9
DESCRIPTION OF HART INTERFACE
176
MFC 300
www.krohne.com 02/2012 - 4000498602 - MA MFC 300 R03 en
Device Status Device C Number Rd / Device Serial No. Rd / Electronic Serial No. Rd
HART Tag / Manufacturer Rd / Write Protect Rd /
Model Rd / Device ID Rd / Universal Rev. Rd /
Device Rev. Rd / Software Rev. Rd / Hardware Rev. Rd /
Date Rd / Final Assembly No. Rd / Sensor Serial No. Rd / Access Level
HART
Standard (overview) Primary variable out of limits
Non-primary variable out of limits
Primary variable analog output saturated
Primary variable analog output fixed
More status information available
Field Device Cold Start
Configuration changed
Malfunction
Failure (device) F Device Error / F IO1 / F Parameter /
F IO2 / F Configuration / F Display /
F Sensor: Global Data Error / Sensor: Local Data Error / F SE Data
Error /
F SE Drive Failure / F SE Hardware Failure / F SE Data Different /
F SE Defective / F Interface PCB Failure / F SE Wiring Error /
F 2 Phase Flow / F Fieldbus /
F Current Output A / F Current Output B / F Current Output C /
F SW User Interface / F Hardware Settings /
F Hardware Detection /
F RAM/ROM Error IO1 / F RAM/ROM Error IO2
Failure (application) F Application Error / F Tube Not Oscillating / F System Control /
F Open Circuit A / F Open Circuit B / F Open Circuit C /
F Wiring A / F Wiring B / F Sensor: Under Range /
F Stop Mode / F Sensor: System Error / F SE Comms. Failure /
F Over Range A (Current) / F Over Range B (Current) /
F Over Range C / F Over Range D /
F Over Range A (Pulse) / F Over Range B (Pulse) /
F Active Settings / F Factory Settings /
F Backup 1Settings / F Backup 2 Settings
Out of specification S Out Of Specification / S Tube Asymmetry / S System Control /
S Startup / S Power Fail / S 2 Phase Flow /
S Excessive Noise / S External Vibration / S Sensor Levels /
S Res. Circ. Defective / S SE Defective / S Interface PCB Failure /
S Density / S Density Calib. Failed / S Sensor Signal Error /
S Temperature Drift / S BE PCB Temperature / S SE PCB
Temperature /
S Tube Temperature / S Overflow Totaliser 1 / S Overflow Totaliser 2 /
S Overflow Totaliser 3 / S Backplane Invalid
Check request C Checks In Progress / C Sensor Electronics /
C Standby Mode / C Zero Calibration
Information I Totaliser 1 Stopped/ I Totaliser 2 Stopped /
I Totaliser 3 Stopped / I Power Fail /
I Control Input A act. / I Control Input B act. /
I Over Range Display 1 / I Over Range Display 2 /
I Backplane Sensor / I Backplane Settings /
I Backplane Difference / I Optical Interface
Process Input Self Test Max. Rec. Temp. Rd / Min. Rec. Temp. Rd /
Information V No. Sensor Rd /
.book Page 176 Monday, February 6, 2012 11:01 AM