Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 98)

Chapter 11. Training Training Profiles
11.4 Power Wave® Manager User Manual IM8002
Training Profiles
Be sure you are connected to the Welding Power Source on which you want to train the welds and that all
components are working properly.
STOP | Be sure you have read Before You Begin Training a Weld
on page 11.1 before you continue.
Figure 11.1 Weld Training Window
For any Weld Profiles in the list with existing limits, green icons appear that represent each limit recorded
for that profile: WeldScore ( ), Time ( ), Amperage ( ), Voltage ( ), and Wire Feed Speed ( ).
 If the Weld Profile contains an active limit (i.e., a check mark in the Enabled checkbox) with
values greater than zero (0), the green icon appears next to that Weld Profile number.
 If the WeldScore™ limit is not enabled and there is a value entered in the field, the icon
appears but is gray.
 If a limit is not enabled or the value for the limit is zero (0), the icon does not appear.
TIP | Generally when you create a training model for a Weld
Profile, only the WeldScore, Time and Wire Feed Speed
icons appear, and sometimes only the WeldScore icon,
depending on how you have chosen to use the Weld Profile.