Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 28)

Chapter 4. Overview of Power Wave® Manager Connecting to the Welding Power Source
4.4 Power Wave® Manager User Manual IM8002
STOP | When you click the OK button, the Welding Power Source
resets and stops welding. Be sure to only click this button if
the power source is not currently welding.
STOP | If the Welding Power Source is currently part of a network,
contact your network administrator to verify you can make
changes to the Ethernet settings of the power source.
To change the network settings (including the IP address) on a power source:
Procedure Details
1. On the Connect tab of Power Wave®
Manager, choose I do not know the IP address
of the welder and select the power source
from the list.
2. Verify the selected Welding Power Source has
a blinking green status light.
This helps you ensure you change the settings on
the intended Welding Power Source.
3. Click the Configure button. The Change Settings window opens.
4. Make your changes. If your computer is directly connected to the
Welding Power Source using an Ethernet cable,
you may click the Suggest Settings button. This
will automatically generate the proper network
settings for the Welding Power Source that would
make it ready to communicate with your
computer.
5. Click OK. The Welding Power Source then resets and
accepts its new network settings.