Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 100)

Chapter 11. Training Training Profiles
11.6 Power Wave® Manager User Manual IM8002
Procedure Details
6. Repeat steps 4 and 5 for each Weld Profile
you want to train during this session.
Power Wave® Manager adds a check mark next to
each profile you have trained during this session and
changes the gray icon ( ) to a star icon ( ). Each
weld training file you add appears with a red icon
( ) to indicate unsaved training data.
7. Once you have finished training the Weld
Profile(s), click the Stop training button at
the top of the window.
8. Click OK when prompted to take the power
source out of training mode.
The system finishes processing all the data and
displays the information under each Weld Profile
(Figure 11.1 on page 11.4).
9. Verify there is a check mark next to each
Weld Profile you want to save to the
Welding Power Source and click the
Apply settings button.
This process takes some time and disables certain
functions in Power Wave® Manager until the
process is complete.
NOTE | Power Wave® Manager also resets the
Welding Power Source when you save the Weld
Profiles to the machine.
Enable WeldScore™ Alerts
1. Select Production Monitoring >
Configuration from the navigation tree.
2. Click the Profile limits tab.
3. Select the Weld Profile.
4. Place a check mark in the Enable checkbox
next to the Minimum WeldScore value.
The gray WeldScore icon ( ) should change to a
green icon ( ).
5. Repeat steps 3 and 4 for each Weld Profile
where you want to monitor WeldScore™.
6. Click Apply settings. Power Wave® Manager saves the changes to the
Welding Power Source.