Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 64)

Chapter 8. Wire Feeder User Interface
8.6 Power Wave® Manager User Manual IM8002
Memory Settings Tab
The Memory Settings section allows you to configure any of the memory buttons that exist on the User
Interface module(s) attached to your welding system. Memory buttons allow you to preset weld settings
for those welds commonly performed using this power source.
NOTE | If the User Interface is a dual feed head system, click the
appropriate feed head button at the top of the list to access
the memory buttons specific to that feed head.
Figure 8.6 Memory Settings Tab
Memory Buttons
The number of memory slots that appear on the Memory Settings tab depends on the number of
buttons on the physical User Interface. To edit a memory button, simply click the memory button to
select it (e.g., Memory 1 in Figure 8.6). The parameters currently set for that memory button appear
on the right.
Each memory button has text that displays on the Mode Select Panel of the User Interface. To change
this text, click the Edit button next to the Memory name field in Power Wave® Manager. Enter the
new name and click OK.