Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 65)

User Interface Chapter 8. Wire Feeder
IM8002 Power Wave® Manager User Manual 8.7
Memory Parameters
To edit a parameter, double-click the entry. The parameter’s edit window opens (Figure 8.7). Simply
enter a new value and click OK. The Weld Modes and parameters that are available for the memory
buttons vary depending on the individual User Interface. Please refer to the appropriate Operator
Manual for details on the memory parameters for your User Interface.
Figure 8.7 Editing Memory Parameters
User Limits
If you have a check mark in the Enable User Limits checkbox, the User Interface enables the User limits
fields for certain parameters and enforces the values defined in the those fields (Figure 8.8). With this
checked, if you enter a value that is above the upper limit, Power Wave® Manager automatically
changes that value to match the upper limit when you click OK. The same is true if you enter a value
that is below the lower limit. The system automatically changes that value to match the lower limit.
For example, if the upper User limit is 410 and you enter a value of 654, Power Wave® Manager
automatically changes the value to 410. If the lower User limit is 60 and you enter a value of 50,
Power Wave® Manager automatically changes the value to 60.
If this is not checked, the values in the User limits fields have no effect.
Figure 8.8 Entering a Limit Higher than the User-Specified Limit
The Machine limits displayed represent the absolute limits of this parameter. The User limits, as well
as the entered value, must be within this range. When finished modifying the parameter, click OK to
write the new settings to the machine.