Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 20)

Chapter 3. Installing Power Wave® Manager Update Welding Power Source Firmware
3.2 Power Wave® Manager User Manual IM8002
Procedure Details
4. In the Quick Links section, click the Power
Wave®, Power Feed®/MAXsa® Software link.
The system displays a page containing the
Download Power Wave® Bundle-FREE button.
5. Click the Download Power Wave® Bundle-FREE
button to run the update.
NOTE | Depending on your Windows version,
you may have to click Run or Allow to permit
your system to launch the file.
The system opens the Lincoln Electric System
Update Utility window where you tell the utility
how to find the Welding Power Source you want
to update.
6. Choose the Connect through Ethernet option
and enter the IP address of the Welding Power
Source you want to update.
TIP | If there is an IP address already
displayed, it is the IP address of the last
Welding Power Source that was connected.
Be sure you enter the correct address for the
current Welding Power Source you want to
update.
You can enter the IP address for the Welding
Power Source in one of two ways:
 Type the specific IP address into the I
know the IP address of the welder field.
 Choosing the I do not know the IP
address of the welder option. The
update utility scans your network and
displays a list of Welding Power Source
IP addresses on the same subnet.
NOTE | If this Welding Power Source has
older firmware, the IP address will not show up
using this method.
TIP | If you run into a problem, please refer to