Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 55)

Ethernet Chapter 7. Network Settings
IM8002 Power Wave® Manager User Manual 7.13
Ethernet
This section provides options for configuring the network settings for the modules connected to the
Welding Power Source through an Ethernet connection.
Multiple Ethernet Modules
If the system to which a Welding Power Source is connected contains more than one Ethernet module (e.g.,
a Power Wave® AC/DC 1000 connected to a System Interface module), you can select the module you want
to review from the drop-down list. This allows you to configure settings for each module connected to the
power source.
Figure 7.11 Multiple Ethernet Module Drop-down
If you’re not sure the selection in the drop-down refers to the actual Ethernet module you want to review,
click the Blink status light button. This causes the status light of the selected module to start blinking
rapidly so you can visually identify the module.
Configuration
The top portion of the Configuration section displays the Welding Power Source’s current network settings,
including IP address, subnet mask and default gateway. (Table 7.3 explains the data under Current settings
in more detail.) The sub-tabs in this section allow you to make modifications to these connection settings,
as well as configure the address of the machines you want to allow access to the Welding Power Source and
adjust the communication speed of the power source over the network.
Figure 7.12 Configuration Tab