Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 46)

Chapter 7. Network Settings DeviceNet
7.4 Power Wave® Manager User Manual IM8002
DeviceNet
The DeviceNet section allows the setup and verification of the DeviceNet connections of various modules to
the Welding Power Source.
NOTE | Modifying DeviceNet settings is highly technical. If you are
uncomfortable with making changes, contact your local IT
support for assistance. You should also consult the
appropriate Lincoln Electric Operator Manual for the
module you have installed.
Multiple DeviceNet Modules
If the system to which a Welding Power Source is connected contains more than one DeviceNet module
(e.g., a Power Wave® connected to a robot teach pendant), you can select the module you want to review
from the drop-down list. This allows you to configure settings for each module.
Figure 7.4 Multiple DeviceNet Module Drop-down
If you’re not sure the selection in the drop-down refers to the actual DeviceNet module you want to review,
click the Blink status light button. This causes the green light on the selected machine to start blinking
rapidly so you can visually identify the module.
Status Tab
The Status tab displays basic information about the DeviceNet interface on the Welding Power Source, as
well as any errors currently present on the interface. Remember: You can select each module connected
using DeviceNet from the Select DeviceNet module drop-down at the top of the window to see information
about that specific module.
Figure 7.5 Status Tab