Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 59)

IM8002 Power Wave® Manager User Manual 8.1
Chapter 8
Wire Feeder
The Wire Feeder section contains settings and diagnostic information for any wire feeders and user
interfaces attached to the Welding Power Source to which you are currently connected with Power Wave®
Manager.
Feeder Settings
In the Feeder Settings section, you can fine tune the behavior of the wire feeders connected to this Welding
Power Source.
Multiple Wire Feeders
If the system to which you have connected (using Power Wave® Manager) contains more than one wire
feeder module, Power Wave® Manager displays the different modules in the Select Wire Feeder module
drop-down. Click the drop-down and select the wire feeder for which you would like to view settings.
Figure 8.1 Multiple Wire Feeder Module Drop-down
If you’re not sure the selection in the drop-down refers to the actual machine you want to review, click the
Blink status light button. This causes the green status light on the wire feeder to start blinking rapidly, and
you can verify you have the correct device selected in Power Wave® Manager.