Lincoln Electric IM8002 POWER WAVE MANAGER - Manual (Page 76)

Chapter 9. Tools Observer
9.10 Power Wave® Manager User Manual IM8002
TIP | To save the data in the charts to a tab-delimited text file,
click the Save chart data button on the top toolbar. Click
the Clear charts button to clear the data from the screen
and start fresh.
TIP | Click the plus icon ( ) at each corner of the chart to
collapse the panel next to it (if available).
Logged Welds Tab
The Logged Welds tab displays a list of the welds that were made during the Observer session. The
Observer session begins when you click into the Observer section of Power Wave® Manager. The session
ends when you close Power Wave® Manager or disconnect the power source. Each weld that you create
during this time appears on the Logged welds tab when the Welding Power Source’s output turns off after
you complete the weld.
Figure 9.9 Logged Welds Tab
TIP | To save the log to a tab-delimited text file, click the Save
weld log button on the top toolbar. To clear the log, click
the Clear weld log button.
Table 9.1 Columns on the Logged Welds Tab
Field Description
Date/time This column represents the date and time that the weld began.
Duration (s) This column represents the length of time (in seconds) from the time listed in the
Date/time column to the time the Welding Power Source stopped welding.
Weld mode This column displays the number of the Weld Mode used for this weld.
Workpoint This column displays the value of the workpoint variable for this weld.
WeldScore™ The application displays the WeldScore™ for this weld. A value appears here only if
you used a Weld Profile for this weld and there was a training model created for
that Weld Profile.