Lincoln Electric IM8002 POWER WAVE MANAGER User Manual
Page 91
Configuration
Chapter 10. Production Monitoring
IM8002
Power Wave® Manager User Manual
10.13
Mail Server Configuration
The following options allow you to configure the Welding Power Source to send e-mail notifications to
the addresses in the Address Book (page 10.13). Table 10.5 explains these options in more detail.
Table 10.5 Configuration Options on the E-mail Setup Tab
Field
Description
Enable e-mail
notifications
Place a check mark in the Enable e-mail notifications checkbox to turn on the
e-mail functions of this power source.
Outgoing mail server
Enter the IP address of the e-mail server on your network.
Mail server port
Enter the port number that the SMTP service uses to connect to the e-mail
server. The standard port number for SMTP servers is 25. Only change this
number if recommended by your local IT department.
DNS server
Enter the IP address of your network’s DNS server. This is only required if
you specified a host name for your mail server, rather than an IP address. If
you are unaware of this information, contact your local IT department.
Power Source name
and Company name
The power source combines these two fields into an e-mail address for the
power source and uses this address for e-mail alerts it generates. Enter the
company’s domain name in the Company name field. There is generally no
need to change the Power Source name field, as it defaults to the current
power source’s name (from the Registration tab) automatically, helping you
maintain a consistent naming convention and ensuring all files using this
name can be easily found and loaded.
Sender E-mail Address
Power Wave® Manager combines the Power Source name and Company
name fields to produce an e-mail address for the power source. When the
Welding Power Source sends an e-mail alert to addresses in the address
book, this e-mail address appears as the sender of the e-mail.
Address Book
The Welding Power Source contains an internal address book, capable of storing up to 12 different e-
mail addresses (62 characters in length or less). You can configure each address to receive an e-mail
notification when one or more events occur within the Welding Power Source (E-mail Triggers on page