Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 769)

Brocade Virtual ADX XML API Programmer’s Guide 759
53-1003248-01
List of Error Messages
A
NET_VLAN_IPS_FAILED_PORT_NOT_CONF Failed to create an IP subnet VLAN (%I/%d) because ports
were not configured in the Layer 2 VLAN %d. Please
configure the ports in the Layer 2 VLAN.
NET_VLAN_IPS_NAME_LENGTH_OUT_OF_RANGE The specified IP Subnet VLAN name is too long. Please
specify a valid VLAN name not more than %d characters.
NET_VLAN_IPS_NOT_FOUND The specified IP subnet VLAN is not found. Please specify
a configured IP subnet VLAN.
NET_VLAN_IPS_PORT_NOT_MEMBER The port "%s" is not the member of Layer 2 VLAN %d.
Please specify a valid port.
NET_VLAN_IPS_ROUT_INT_CONF The router interface has been configured on another
VLAN. Please specify a different router interface.
NET_VLAN_IPS_ST_PORT_NOT_CONF The static port is not configured. Please specify a
configured static port.
NET_VLAN_IPS_ZERO_ADD The broadcast address or zero address is not allowed.
Please specify a valid IP address.
NET_VLAN_L2_VLAN_LEFT There are only a few Layer 2 VLAN entries left. There is
only %d free L2 VLAN entries left.
NET_VLAN_LCAP_PORTS Some of the specified ports are running LACP and cannot
be tagged as ports. The ports that are running LACP
cannot be tagged as ports.
NET_VLAN_MISSING The VLAN ID is missing. Please specify a valid VLAN ID.
NET_VLAN_NAME_TOO_LONG The specified VLAN name is too long. Please specify a
valid VLAN name not more than %d characters.
NET_VLAN_NO_FIDS There are insufficient FIDs available to create the VLAN
group. Please ensure that there are enough FIDs
available before creating a VLAN group.
NET_VLAN_NO_FREE_L2_VLAN There is no more free Layer 2 VLAN entry left.
NET_VLAN_NOT_ALLOTED_BY_MASTER The specified port(s) %s is %s on the VLAN %d owned by
the tenant %s. Please enter the valid port and try again.
NET_VLAN_PORT_NOT_ALLOTED_BY_MASTER The specified port(s) %s have not been allocated by the
master for this tenant. Please allocate the port by master
and try again.
NET_VLAN_PORT_NOT_MEMBER_OF_DEFAULT The specified port "%s" is not a member of the default
VLAN. Please specify the existing port.
NET_VLAN_PORT_NOT_MEMBER_OF_VLAN The specified port(s) "%s" are not member(s) of VLAN %d.
Please specify only the member ports that belong to the
VLAN %d.
NET_VLAN_PROTOCOL_VLAN_CONFIGURED The specified IP subnet VLAN (%I/%d) cannot be created.
The IP subnet VLAN can be created only when IP protocol
VLAN is not configured.
NET_VLAN_REMOVE_LINK_KEEP_ALIVE Link keepalive configuration is available on the specified
VLAN %d. Please remove the link keepalive configuration
on the VLAN.
TABLE 109 List of error messages
Error String Message