Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 752)

742 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
List of Error Messages
A
NET_INT_INVALID_UNICAST_ADDRESS The specified unicast IP address %s in the interface %P is
invalid. Please specify a valid unicast IP address.
NET_INT_IP_ADDRESS_INVALID The specified IP address %s on the interface %P is invalid.
Please specify a valid IPv4 or IPv6 address on the
interface.
NET_INT_IP_ADDRESS_NOT_FOUND_FOR_SYN_DEFE
NSE The specified interface %P does not have any IP
addresses configured. Please configure IP address on the
interface before enabling SYN defense.
NET_INT_IP_ADDRESS_NOT_FOUND_FOR_SYN_PRO
XY The specified interface %P does not have any IP
addresses configured. Please configure IP address on the
interface before enabling SYN proxy.
NET_INT_IP_IN_USE_BY_BACKUP_VRRP_ROUTER The specified IP address %I for interface %P is in use by
the backup VRRP router. Please specify a unique IP
address.
NET_INT_IP_IN_USE_BY_EXTENDED_VRRP_ROUTER The specified IP address %I for interface %P is in use by
the VRRP-Extended router. Please specify a unique IP
address.
NET_INT_IP_INFO_NEEDED The interface IP address is missing. Please specify valid
interface IP address.
NET_INT_IP_UNSUPPORTED_ON_SWITCH The specified interface does not support configuration or
access to IP addresses in Switch mode. Please specify
the Management interface.
NET_INT_IPPROTO_OR_IPSUBNET_VLAN_UNSUPPOR
TED The specified interface %P is an IP protocol or IP subnet
VLAN dynamic port. Please specify an interface which is
not an IP protocol or IP subnet VLAN dynamic port.
NET_INT_IPV4_ADDRESS_INVALID The specified IP address %I in the interface %P is invalid.
Please specify a valid IP address which belongs to Class A
or B or C.
NET_INT_IPV4_ADDRESS_MULTIPLE_FLAGS_UNSUP
PORTED More than one flag (secondary, ignore OSPF or passive
OSPF) is specified for the interface %P. Please specify
only one flag.
NET_INT_IPV4_SUBNET_MASK_OVERLAP The IP %I, subnet mask %I in the interface %P overlaps
with another interface. Please specify a non overlapping
IP and subnetmask.
NET_INT_IPV6_ACL_CONFIGURED The specified interface %P has IPv6 ACLs configured,
cannot disable IPv6. Please remove the IPv6 ACLs, before
disabling IPv6 on this interface.
NET_INT_IPV6_ADDRESS_EXIST The specified interface %P has configured IPv6
addresses, cannot disable IPv6. Please delete the
configured IPv6 addresses, before disabling IPv6.
NET_INT_IPV6_ADDRESS_MULTIPLE_FLAGS_UNSUP
PORTED More than one flag (link-local, anycast or EUI-64) is
specified for the interface %P. Please specify only one
flag.
NET_INT_IPV6_ADDRESS_NOT_FOUND The specified IPv6 address %s is not found in the
interface %P. Please specify an IPv6 address which
already exists.
TABLE 109 List of error messages
Error String Message