Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 106)

96 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
Data structures
3
HABackupNodeStats
This structure is the high-level description of a backup node statistics.
backupTimer unsignedInt Optional The valid
values are
between 5
and 100. Specifies how long the VirtualADX, when it
is the backup Brocade Virtual ADX, will wait
for a Hello message or synchronization
data from the active Brocade Virtual ADX
before assuming the active Brocade Virtual
ADX is no longer available. The unit is 100
milliseconds.
backupPreference unsignedInt Optional The valid
values
between 5
and 30. The wait time for a Brocade Virtual ADX
device before taking the active role. Its unit
is in minutes.
enableBackupVipCo
unt boolean Optional If it is enabled then failover is based not
only on router ports and server ports but
also active VIPs count.
enableBackupVipPo
rtCount boolean Optional If this is enabled then the fail over happens
based on router ports and active virtual
ports.
failoverDelay unsignedInt Optional The valid
values are
between 0
and 1200. Specifies the number of seconds that the
Brocade Virtual ADX device will wait before
performing a failover. The values that can
be specified are from 0 through 1200
seconds.
enableRemainStan
dby boolean Optional If it is enabled then the Brocade Virtual
ADX device will always be in standby mode
only. At any circumstance it can’t be in
active mode unless this configuration is
disabled.
forwardL4Syncv boolean Optional If it is enabled then Brocade Virtual ADX
will forward synching messages instead of
intercepting if they are not meant for it.
enablebackupTrunk
PortCount boolean Optional If this is enabled then the total number of
ports in a trunk will be added to the router
port count. Otherwise, 1 is added for every
trunk port.
backupSyncDisable boolean
TABLE 238 Attributes
Name Type Required Rules Description
nodeState haStatusEnum Optional Runtime state (active/standby) of the
switch.
slbState haSlbStateEnum Optional Server load balancing state for the
switch.
isPartnerMacAddressValid boolean Optional States whether it has valid MAC address
of the partner.
TABLE 237 Attributes (Continued)
Name Type Required Rules Description