Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 153)

Brocade Virtual ADX XML API Programmer’s Guide 143
53-1003248-01
Enumerations
3
authorizationConfigParametersEnum
This structure is a high-level description of Authorization configuration parameters enumerated list.
arpTypeEnum
This structure is a high-level description of ARP type enumerated list.
bannerMessageTypeEnum
This structure is a high-level description of Banner message enumerated list.
bpStateEnum
These are the enumerations for BP states.
TABLE 346 Attributes
Parameters Description
EXEC_MODE_AUTHORIZATION_METHOD Exec mode authorization method
EXEC_COMMANDS_PRIV_AUTHORIZATION Exec commands priv authorization
TABLE 347 Attributes
Parameters Description
DYNAMIC The switch learned the entry from an incoming packet.
STATIC The switch loaded the entry from the static ARP table when the device for the entry was
connected to the switch.
PENDING The ARP entry will be in Pend (pending) status until traffic with the matching IP-to-MAC
is received on a port.
INVALID An invalid ARP entry.
OTHER ARP state is not pending, static, dynamic, or invalid.
TABLE 348 Attributes
Parameters Description
MESSAGE_OF THE DAY Set Message-of-the-day banner (default)
CONNECTION_MESSAGE Set incoming terminal line banner.
EXEC_MESSAGE Set EXEC process creation banner.
TABLE 349 Attributes
Parameters Description
BOOT_IMAGE_STATE Boot image state
POWERED Powered
BOOT_DIAG_FAILED Boot diag failed
BOOT_DIAG_OK Boot diag OK
IMAGE_LOAD_FAILED_OR_SKIPPED Image load failed or skipped
BP_NOT_READY BP not ready