Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 160)

150 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
Enumerations
3
haModeEnum
These are the enumerations for and ADX high availability mode enumerated list.
haNodeAttributeEnum
These are the enumerations of high backup node configuration attributes enumerated list.
TABLE 367 Attributes
Parameters Description
HOT_STANDBY Hot standby mode.
SYMMETRIC_SLB Symmetric SLB mode.
SYMMETRIC_ACTIVE Symmetric active mode.
NOT_CONFIGURED Not configured.
TABLE 368 Attributes
Parameters Description
BACKUP_GROUPID The backup group ID.
SHARED_CHASSIS_MAC_ADDR The shared chassis MAC address.
SWITCH_STATE The switch state.
BACKUP_ROUTER_PORTS The backup router ports.
BACKUP_TIMER The backup timer.
BACKUP_PREFERENCE The backup preference.
ENABLE_BACKUP_VIP_COUNT Enable VIP counts.
ENABLE_BACKUP_VIP_PORT_COUNT Enable VIP port count.
BACKUP_DELAY The backup delay.
ENABLE_REMAIN_STANDBY Always be in standby mode.
FORWARD_L4SYNC Forward sync messages to ther devices.
ENABLE_BACKUP_TRUNKPORT_COUNT Enable the trunk port to be counted individually.
SYMMETRIC_PDU_RATE The symmetric PDU rate.
SYMMETRIC_PORT The symmetric port for sync messages.
SYMMETRIC_MAC The symmetric MAC.
SYMMETRIC_REACTIVATION_DELAY The reactivation delay in symmetric mode.
SYMMETRIC_GROUP_ID The symmetric group ID.
ACTIVE_ACTIVE_PORT The port number in active-active mode for the sync message.
ALLOW_PASS_THROUGH_VIP_TRAFFIC Forwards VIP traffic that do not belong to any VIP.
SOURCE_IP The source IP address.
STANDBY_SOURCE_IP The standby source IP.
ENABLE_SOURCE_NAT Enables source NAT in the Brocade Virtual ADX switch.
SOURCE_NAT_IP The source NAT IP.