Brocade Virtual ADX XML API Programmer’s Guide (Supporting ADX v03.1.00) - Manual (Page 110)

100 Brocade Virtual ADX XML API Programmer’s Guide
53-1003248-01
Data structures
3
HAStatusSummary
This structure is the high-level description of the HA status summary.
HASymmetricPduRate
This structure is the high-level description of a interval and wait time for SSLB discovery packets.
portString string Interface port string. For example:
•
Ethernet “1” or “1/1” etc.
•
Loopback “lb1” or “lb2” etc.
•
Virtual “ve1” or “ve2” etc.
•
Management “mgmt1” only.
vlanID unsignedInt Identifies the VLAN ID of the VLAN to
which the port belongs.
TABLE 244 Attributes
Name Type Required Rules Description
hotStandbySupported boolean Optional Identifies if ADX is capable of
supporting the Hot Standby HA
mode.
hotStandbyEnabled boolean Optional If the Hot Standby mode
enabled on the ADX or not.
BackupPort HAVipGroupConfiguration Optional Details of the HA link between
Active and Standby
symmetricPort HASymmetricPort Optional
sessionSynEnabledCount unsignedInt Optional Number of ports on which
Session sync has been enabled
symmetricActiveEnabledCount unsignedInt Optional Number of VIPs which are
enabled for Symmetric Active.
symmetricSlbEnabledCount unsignedInt Optional
TABLE 245 Attributes
Name Type Required Rules Description
sendIntervalMultiplier unsignedInt Optional Valid values are
beween 1 to
100 The multiplier for the SSLB protocol
interval.
waitIntervalMultiplier unsignedInt Optional Specifies how many multiples of the
discovery interval the SI will wait for an
SSLB discovery packet.
TABLE 243 Attributes
Name Type Required Rules Description