beautypg.com

7 communication with the master station, Pcon-ca/cf a cc-link – IAI America PCON-CFA User Manual

Page 96

background image

4. PCON-CA/CF

A

CC-Link

90

4.7 Communication with the Master Station

The remote device station consists of 2 words for each I/O point and 4 words for the remote I/O data register
per station.
Set the station data for the master station to the number of stations setup in the operation mode for each
station No.

4.7.1 Each Operation Mode and Corresponding Allocated PLC Addresses

The addresses allocated for each operation mode are described as follows.
x

PLC Output o PCON-CA/CFA Input (* “n” shows the head register address per each axis).

PCON-CA/CFA DI and Input data register

Remote I/O mode

Position/Simplified

Direct Value Mode

Half Direct Value

Mode

Full Direct Value

Mode

Remote I/O mode 2

PLC address

Number of occupied

stations: 1 Station

Number of occupied

stations: 1 Station

Number of occupied

stations: 2 Stations

Number of occupied

stations: 4 Stations

Number of occupied

stations: 1 Station

RY n0 – nF

Port No.0 – 15

Occupied Area

Port No.0 – 15

RY

(n+1)0 – (n+1)F

System Area

System Area

System Area

RY

(n+2)0 – (n+2)F

Occupied Area

RY

(n+3)0 – (n+3)F

System Area

RY

(n+4)0 – (n+4)F

RY

(n+5)0 – (n+5)F

RY

(n+6)0 – (n+6)F

Occupied Area

RY

(n+7)0 – (n+7)F

System Area

RWw (n+0)

RWw (n+1)

Target Position

Target Position

Target Position

RWw (n+2)

Command position

number

RWw (n+3)

Occupied Area

Control Signal

Positioning Width

Positioning Width

Occupied Area

RWw (n+4)

Speed

RWw (n+5)

Acceleration/

Deceleration

Speed

RWw (n+6)

Pressing Current

Limit Value

RWw (n+7)

Control signal

Zone Value “+”

RWw (n+8)

RWw (n+9)

Zone Value “-”

RWw (n+A)

Acceleration

RWw (n+B)

Deceleration

RWw (n+C)

Pressing Current

Limit Value

RWw (n+D)

Load Current

Threshold

RWw (n+E)

Control signal 1

RWw (n+F)

Control signal 2

Note: The Occupied Area stands for the area occupied by means of the setting of the number of remote device

stations.
The System Area stands for the system area of the remote device station.
These areas are not used for any other purpose. Also take care about duplicating the use of the data register.

This manual is related to the following products: