Avaya Cajun P880 - Manual (Page 55)

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Avaya ATM Uplink Module CLI Commands
1-45
set lec (trigger-count)
Command Mode
Configuration
Description
Sets the maximum number of Frames per second that the ATM
Uplink module will send to the BUS for forwarding rather than
establish a data direct VCC to the LEC.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
Syntax
set lec trigger-count
Table 1-36. Parameters, Keywords, Arguments
Sample Output
This example sets the trigger count for LEC 2 to a programmed time
interval of 15.
ATM(configure)# set lec 2 disable
LEC 2 has been disabled
ATM(configure)# set lec 2 trigger-count 15
LE ARP Trigger Count 15 has been set for LEC 2
ATM(configure)# set lec 2 enable
LEC 2 has been enabled
Name Definition
lecID The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
trigger-count-value The LE ARP trigger count measured in
seconds. The range of values is: Minimum = 1,
Maximum = 20.