Avaya Cajun P880 - Manual (Page 37)

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Avaya ATM Uplink Module CLI Commands
1-27
set interface (medium-type)
Command Mode
Configuration
Description
Set the ATM interface medium type to SONET or SDH. The default
value for the medium type is SONET
* Note: You must disable an interface each time you make a
change to the configuration. After you make
configuration changes, you must enable the interface in
order for the changes to take effect.
Syntax
set interface medium-type
{sonet | sdh}
Table 1-20. Parameters, Keywords, Arguments
Sample Output
This example disables interface 1, sets the medium type to SONET
and enables interface 1.
ATM(configure)# set interface 1 disable
Interface 1 has been disabled
ATM(configure)# set interface 1 medium-type
sonet
Medium Type SONET has been set for Interface 1
ATM(configure)# set interface 1 enable
Interface 1 has been enabled
Name Definition
interfaceID The ATM interface identification number. The
range of values is: Minimum = 1, Maximum = 2
where 1 is Physical port 1 and 2 is physical port 2.
sonet | sdh Select either medium type:
• sonet - Synchronous Optical Network. A
high-speed synchronous network
specification developed by Bellcore, designed
to run on optical fiber. STS-1 (51.84 Mbps) is
the basic building block of SONET.
• sdh - Synchronous Digital Hierarchy. A
European standard that defines a set of rate
and format standards that are transmitted
using optical signals over fiber. SDH is similar
to SONET, with a basic SDH rate of 51.84
Mbps, designated at STM-0.