Avaya Cajun P880 - Manual (Page 26)

1-16
Chapter 1
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
set atm-link oam-loopback
Command Mode
Configuration
Description
Enables or disables OAM-Loopback for the ATM-Link. Enabling
OAM Loopback configures the ATM-Link to send an OAM F5 packet
every seconds down the default PVC. The ATM-Link will also echo
OAM cells back along the default PVC.
* Note: This is applicable only to Simple-Bridge and LLC Mux
VSPs. OAM is not supported with Routed VSPs.
Syntax
set atm-link oam-loopback {enable |
disable}
Table 1-13. Arguments, Parameters, Keywords
Sample Output
This example enables OAM Loopback on ATM Link AvayaLink.
ATM(configure)# set atm-link AvayaLink oam-
loopback enable
OAM Loopback ATM Link AvayaLink set to
enabled.
Name Definition
link-name Name of the ATM Link.
Use th e show atm-link [
id>] to get the name of an ATM-Link whose
name is greater than 10 characters.
enable | disable Enables or disables OAM loopback for the ATM
Link