Avaya Cajun P880 - Manual (Page 152)

1-142
Chapter 1
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
set vsport load-share
Command Mode
Configuration
Description
Sets the Virtual Switch Port identified by vsportId to be a load-
sharing port. This presumes that the VSP Simple-Bridge or LLC Mux
Bridge. Further, for load share to work, you must also specify pairs
of ATM-Links by setting the Failover-Link parameter within each
ATM Link. In other words, you need two ATM Links to balance
across for each remote destination; and, you should have one ATM
Link per physical port for each pair.
* Note: Loadsharing is not supported for Routed VSPs.
Syntax
set vsport load-share {yes | no}
Table 1-90. Arguments, Parameters, Keywords
Sample Output
The following example enables VSP 4 for load sharing.
ATM(Configure)# set vsport 4 load-share yes
LoadShare Yes has been set for VSPort 4
Name Definition
vsportId Virtual Switched Port Identifier. Possible values
range from 1 - 128.