Avaya Cajun P880 - Manual (Page 141)

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Avaya ATM Uplink Module CLI Commands
1-131
set vport (path-cost)
Command Mode
Configuration
Description
Set the path cost for routing over an ATM interface for the virtual
port.
* Note: You must disable a VPORT each time you make a change
to the configuration. After you make configuration
changes, you must enable the VPORT in order for the
changes to take effect.
Syntax
set vport path-cost
Table 1-81. Parameters, Keywords, Arguments
Sample Output
This example sets the path cost for VPORT 1 5 to 15000000.
ATM(configure)# set vport 1 5 disable
VPort 1 5 has been disabled
ATM(configure)# set vport 1 5 path-cost
15000000
VPort 1 5 modified
ATM(configure)# set vport 1 5 enable
VPort 1 5 has been enabled
Name Definition
interfaceID The ATM Interface number. The range of
values is: Minimum = 1, Maximum = 2.
vpiNumber The VPI number. The range of values is:
Minimum = 0, Maximum = 255.
path-cost-value The value of the path cost for routing over an
ATM Interface. The range of values is:
Minimum = 0, Maximum = 16777215