Avaya Cajun P880 - Manual (Page 140)

1-130
Chapter 1
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
set vport (name)
Command Mode
Configuration
Description
Sets the virtual port’s name.
* Note: You must disable a VPORT each time you make a change
to the configuration. After you make configuration
changes, you must enable the VPORT in order for the
changes to take effect.
Syntax
set vport name
Table 1-80. Parameters, Keywords, Arguments
Sample Output
This example sets the name of VPORT 1 5 to “dawes.”
ATM(configure)# set vport 1 5 disable
VPort 1 5 has been disabled
ATM(configure)# set vport 1 5 name dawes
VPort 1 5 modified
ATM(configure)# set vport 1 5 enable
VPort 1 5 has been enabled
Name Definition
interfaceID The ATM Interface number. The range of
values is: Minimum = 1, Maximum = 2.
vpiNumber The VPI number. The range of values is:
Minimum = 0, Maximum = 255.
vportName The VPORT name. The VPORT name must be
between 1 and 31 characters (alpha or
numeric).