Avaya Cajun P880 - Manual (Page 15)

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Avaya ATM Uplink Module CLI Commands
1-5
Accessing/Exiting the ATM Uplink CLI
To access the ATM Uplink CLI, you must first access the Avaya
Multiservice Swith’s Supervisor console. There are two ways to
access the Supervisor console:
■
Using a serial interface
■
Using telnet
Using a Serial Interface to Access the
Avaya Multiservice Switch’s Supervisor
To access the CLI using a serial interface (such as HyperTerminal):
1. Set up a new connection within the serial interface. Table 1-5
describes how the serial interface should be configured.
Table 1-5. Serial Interface Configuration
2. Connect with the host as directed by the instructions in the
specific serial interface software you are using.
3. Enter your user name and password at the respective
prompts.
Using Telnet to Access the Avaya Multiservice Switch’s Super-
visor
To use telnet to access the Avaya Multiservice Swith’s Supervisor:
Parameter Setting
Baud Rate 9600
Data Bits 8
Stop Bits 1
Parity None
Flow Control None