Accessing the atm uplink cli, Exiting the atm uplink cli – Avaya Cajun P880 User Manual
Page 16

1-6
Chapter 1
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
* Note: A serial interface should be used to configure an IP
address and user account for the switch. Default
accounts are:
•
root
•
diag
•
manuf
1. Obtain the name and password for the user account you will
be using.
2. At the system prompt, enter telnet and the IP address.
telnet
3. Enter your user name and password at the respective
prompts.
Accessing the ATM Uplink CLI
To access the ATM Uplink CLI, enter session and the slot number
(Example: session 2). The prompt changes to
ATM-2>, indicating
that you are logged into the ATM Uplink CLI.
* Note: The prompt reflects the change of mode.
Exiting the ATM Uplink CLI
To exit the ATM Uplink CLI:
1. Enter exit at the system prompt, as many times as necessary,
until you have returned to the User mode.
2. Enter quit to end the ATM Uplink CLI session. You are
returned to the Supervisor prompt and can disconnect from
telnet or the serial interface.