Avaya Cajun P880 - Manual (Page 143)

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Avaya ATM Uplink Module CLI Commands
1-133
set vport (traffic-shape-rate)
Command Mode
Configuration
Description
Configure output maximum number of cells transmitted (or
throttling) on this VPORT.
* Note: You must disable a VPORT each time you make a change
to the configuration. After you make configuration
changes, you must enable the VPORT in order for the
changes to take effect.
Syntax
set vport traffic-shape-
rate
Table 1-83. Parameters, Keywords, Arguments
Sample Output
This example sets the output throttling on VPORT 1 5 to 0.
ATM(configure)# set vport 1 5 disable
VPort 1 5 has been disabled
ATM(configure)# set vport 1 5 traffic-shape-
rate 3500
VPort 1 5 modified
ATM(configure)# set vport 1 5 enable
VPort 1 5 has been enabled
Name Definition
interfaceID The ATM interface number. The range of
values is: Minimum = 1, Maximum = 2.
vpiNumber The VPI number. The range of values is:
Minimum = 0, Maximum = 255.
cellrate Output throttling on a VPORT. The range of
values is: Minimum = 3500, Maximum =
1412830 for OC12 or 353207 for OC3.