Set interface (enable | disable), Command mode, Description – Avaya Cajun P880 User Manual
Page 36: Syntax, Sample output
1-26
Chapter 1
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
set interface (enable | disable)
Command Mode
Configuration
Description
Enable or disable a physical interface to the ATM interface. Physical
port 1 is interfaceID 1 and physical port 2 is interfaceID 2.
* Note: You must disable an interface each time you make a
change to the configuration. After you make
configuration changes, you must enable the interface in
order for the interface to be operational.
Syntax
set interface
medium-type | name}
Table 1-19. Parameters, Keywords, Arguments
Sample Output
This example shows interface 1 being disabled and enabled.
ATM(configure)# set interface 1 disable
Interface 1 has been disabled
ATM(configure)# set interface 1 enable
Interface 1 has been enabled
Name
Definition
interfaceID
The ATM interface identification number. The
range of values is: Minimum = 1, Maximum =
2.
enable | disable |
medium-type |
name
enable - Enables the ATM interface
disable - Disables the ATM interface
medium-type - options are SDH or SONET.
see
“set interface (medium-type)” on page 27
name - set the ATM interface name. see
“set
interface (name)” on page 28