Set vsport static-laft, Command mode, Description – Avaya Cajun P880 User Manual
Page 154: Syntax, Sample output

1-144
Chapter 1
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
set vsport static-laft
Command Mode
Configuration
Description
Configure a static LANE Address Forwarding Table (LAFT) entry.
The ATM Uplink module manages RFC1483 VSPs as if they were
LANE Clients. A static LAFT entry allows you to manually associate
a remote MAC address with an ATM Link. Use the no version of this
command to clear a static LAFT entry.
* Note: Static LAFT Entries are not supported for Routed VSPs.
Syntax
set vsport
Table 1-92. Arguments, Parameters, Keywords
Sample Output
The following example creates then deletes a static LAFT entry to
MAC address 00:11:22:33:44:55 on ATM Link EngLink in VSP 12.
ATM(Configure)# set vsport 12 static-laft 00:11:22:33:44:55
EngLink
Entry MAC[00:11:22:33:44:55] VLAN[0] successfully added
ATM(Configure)# no static-laft 12 00:11:22:33:44:55
Entry MAC[00:11:22:33:44:55] VLAN[0] successfully deleted
Name
Definition
vsportId
Virtual Switched Port Identifier. Possible values
range from 1 - 128.
MACAddr
Remote MAC address.
link-name
The ATM Link associated with the MAC
address. (1 to 32 Characters)