beautypg.com

Set lec (server-addr), Command mode, Description – Avaya Cajun P880 User Manual

Page 54: Syntax, Sample output

background image

1-44

Chapter 1

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0

set lec (server-addr)

Command Mode

Configuration

Description

Set the server ATM Address used by the LEC to connect to the
ELAN.

* Note: You must disable a LEC each time you make a change to

the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.

Syntax

set lec server-addr

{ | default>}

Table 1-35. Parameters, Keywords, Arguments

Sample Output

This example sets the server ATM address for LEC 2 to default.

ATM(configure)# set lec 2 disable

LEC 2 has been disabled

ATM(configure)# set lec 2 server-addr default

Server ATM Address DEFAULT has been set for

LEC 2

ATM(configure)# set lec 2 enable

LEC 2 has been enabled

Name

Definition

lecID

The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.

atm-address | default

The server ATM address. Options are the
20 byte ATM address of the server or the
default well-known address.