Set atm-link failover-link, Command mode, Description – Avaya Cajun P880 User Manual
Page 23: Syntax, Sample output

Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Avaya ATM Uplink Module CLI Commands
1-13
set atm-link failover-link
Command Mode
Configuration
Description
Sets the atm failover-link. The ATM Uplink module supports a
failover link. In the event one link fails, the traffic will be forwarded
by the failover link.
Syntax
set atm-link
* Note: none is used to clear the failover link setting for this
ATM Link.
* Note: This command applies only to Non-Routed VSP ATM
Links.
Table 1-10. Arguments, Parameters, Keywords
Sample Output
The following example sets the failover-link for ATM Link MainLink
to ATM Link BackupLink. Should MainLink fail, BackupLink will
begin to forward the traffic.
ATM(configure)# set atm-link MainLink
failover-link BackupLink
Failover link BackupLink has been set for ATM
Link MainLink
The following example clears the failover-link for ATM Link
MainLink. Should MainLink fail, no backup is specified and traffic
will not flow.
ATM(configure)# set atm-link MainLink
failover-link none
Failover link none has been set for ATM Link
MainLink
Name
Definition
link-name
The name of the ATM link whose failover link
you will specify.
Use th
e show atm-link
id>]
to get the name of an ATM-Link whose
name is greater than 10 characters.