Extron Electronics HDXP Plus Series User Guide - Manual (Page 91)

HDXP Plus Series Switchers • Matrix Software 85
Tools menu
The Tools menu contains the following options. (Grayed out
options are unavailable on your switcher.)
• Assign Device Icons — Displays the complete set of input
and output device icons. You can drag any of these icons to
the input and output boxes.
• Edit Device Palette — Allows you to add your own device
icon graphics.
• Mute-Output settings — Displays the Channel Mute
Settings window. On this screen, use the slider bar to select
an output to mute, then select the
Video check box in the
Mute section. To mute all outputs at once, select the All
check box.
Figure 83. Channel Mute Settings Window
• HDXP Reclocker Rate settings — Opens the Channel Mute Settings window, on
which you can use the Reclocker Rate menu to select a rate at which outputs will
be reclocked to put them in sync with input signals.
• View Input Frequencies — (DSVP) Displays the input horizontal and vertical
frequencies for each input.
• Update Firmware — Allows you to replace the firmware that is coded on the switcher
control board without needing to take the HDXP out of service, open the switcher
enclosure, and replace the firmware chip set (see
Updating the Firmware on
page 81).
• IP Options — Allows you to set options for the IP connection (see IP Setup on
page 75).
• HTML File Manager — Displays a list of HTML files installed on the switcher
and allows you to upload custom files from a connected PC to the switcher (see
Uploading HTML Files on page 83).