Extron Electronics HDXP Plus Series User Guide - Manual (Page 115)

HDXP Plus Series Switchers • HTML Configuration and Control 109
Set and View Ties Page
You can create ties on the Set and View Ties page (see figure 105). Access the Set and
View Ties page by selecting the
Control tab.
Figure 105. Set and View Ties Page
The Set and View Ties page consists of a matrix of input (rows) and output (columns)
selection buttons.
Creating a Tie
Select and switch an input as follows:
1. Move the mouse over the matrix of input and output selection buttons. Click a button
to create a preliminary tie of the input and output associated with that button (if they
are not already tied) or a preliminary untie (if the input and output are tied). A
P (for
preliminary) appears on the button.
NOTES:
• If you lose track of the input and output associated with a specific button,
let the mouse rest over one of the tie buttons for a moment. A field pops up
(see figure 105) that identifies the input and output for that button.
• To tie an input to all outputs, click the input number, located at the left of the
matrix.
2. Click the Take button to make the configuration changes or Cancel button to
abandon the changes.