Extron Electronics HDXP Plus Series User Guide User Manual
Page 34
HDXP Plus Series Switchers • Operation
28
3.
Press and release one of the Control buttons to select a group number:
•
Press the Enter button to select group 1.
•
Press the Preset button to select group 2.
•
Press the View
<
button to select group 3.
•
Press the Esc
>
button to select group 4.
In the figure 39 example, group 1 is being selected.
CONTROL
PRESET
ENTER
ESC
VIEW
Press the Enter button to select group 1
.
The button lights
amber to indicate the selection.
Group# 1 2 3 4
Figure 39.
Selecting an I/O Group Number
4.
Select the desired inputs and outputs to assign to the group by pressing their input
and output buttons. In the example below, inputs and outputs 1 through 4 are being
selected.
1 2 3 4 5 6 7 8
INPUTS
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
OUTPUT
Press and release Input buttons 1 through 4. The selected buttons light.
Press and release Output buttons 1 through 4. The selected buttons light.
Figure 40.
Assigning Inputs and Outputs to a Group
5.
In order for an input group to be functional, you must create more than one group.
Repeat steps 3 and 4 to create a second input group.
6.
If you want to create more I/O groups, repeat steps 3 and 4
again.
7.
When finished grouping, press and release the Matrix and Preview buttons to exit the
I/O grouping mode.
I / O
MATRIX PREVIEW
Press the Matrix and Preview button
simultaneously to exit I/O grouping mode.
Figure 41.
Exiting I/O Grouping Mode
Alternatively, you can allow the mode to time out by waiting approximately 30
seconds.