EVS IPDirector Version 5.6 - May 2009 Part 7 User's Manual - Manual (Page 185)

Issue 5.6.A IPDirector V.5.6 – User Manual – Part 7: Editing - IPEdit
EVS Broadcast Equipment - 2009
176
4.15 REPLACING PARTS OF A TIMELINE TO
ADD EXTERNAL EFFECTS
4.15.1 G
ENERAL
I
NFORMATION ON THE
R
EPLACE
F
UNCTION
D
EFINITION
The purpose of the Replace function is to replace some parts of a timeline with the
initial A/V material to which audio or video effects have been added. Typical use
is to add graphical effects inside a video track or to add mixed audio as voice-over
to an audio track.
P
ROCESS
The general process can be summarized as follows:
Step See …
1. The user first needs to assign a recorder channel to
IPEdit to be able to use the Replace function. Section 4.15.2, on
page 177.
2. The user defines the Replace settings, including preroll,
audio remapping and optional GPI triggers for external
devices in use.
Section 4.15.3, on
page 178.
3. The user specifies the range of the timeline to be
replaced by defining a mark IN point and, possibly a
mark OUT point in the timeline. The mark OUT points for
the Replace function are optional. If no out point exists,
the editor is performing an open-ended replace and can
stop the replace when desired.
Section 4.15.4, on
page 186.
4. The user initiates the Replace process. This can be
done by pressing the Replace icon above the
timeline or CTRL+ .
Section 4.15.4, on
page 186.
5. The resulting A/V material is ingested back to the XT[2]
server via the assigned recorder channel. Section 4.15.4, on
page 186.
6. A newly created clip based on this ingested material will
directly replace the defined range in the timeline. The
new clip includes a fixed guardband IN and OUT of 1
second.
Section 4.15.4, on
page 186.