EVS IPDirector Version 5.6 - May 2009 Part 7 User's Manual - Manual (Page 173)

Issue 5.6.A IPDirector V.5.6 – User Manual – Part 7: Editing - IPEdit
EVS Broadcast Equipment - 2009
164
4.13.9 M
ODIFYING
A
UDIO
S
WAPS
H
OW TO
M
ODIFY A
S
WAP OR
M
UTE ON ONE OR
M
ORE
E
LEMENTS OF AN
A
UDIO
T
RACK
To modify a swap or mute defined on one or more elements of an audio track,
proceed as follows:
1. In the general timeline display, select the elements of a track on which you
want to modify the swap. For a multiple selection, select the elements while
pressing CTRL.
2. Right-click one of the selected elements and select Modify Swap/Mute.
The Swap/Mute Configuration window opens with the parameters defined on
the first swapped element of the selection.
3. Do one of the following to modify or add a swap or mute:
• For a swap, click in the matrix at the intersection between the source
channel to play and the output channel on which the source should be
played.
• For mute, click in the matrix on the bullet located on the line of the output
channel to mute. If you click again, the bullet reappears and the channel
is no longer muted.
4. Repeat the step 3 on all the channels that you want to swap or mute.
5. Click Apply.
The selected swaps or mutes are modified according to the new settings.
H
OW TO
M
ODIFY A
S
WAP OR
M
UTE
D
EFINED
F
ROM AND TO
G
IVEN
P
OINTS OF A
T
RACK
To modify an audio swap or mute defined on a part of an audio track, proceed as
follows:
1.
In the general timeline display, click the Swap/Mute Zoom icon on the
right of the track on which to add the swap or mute.
The track is displayed in Swap/Mute Zoom mode.
2. Select the swaps you want to modify in one of the following ways:
• Lasso the swap point(s) to select from right to left.
• Right-click the swap point(s) to select, keeping CTRL pressed for multiple
selections.
3. Right-click and select Modify Swap/Mute.
The Swap/Mute Configuration window opens.