EVS IPDirector Version 5.6 - May 2009 Part 7 User's Manual - Manual (Page 166)

IPDirector V.5.6 – User Manual – Part 7: Editing - IPEdit
EVS Broadcast Equipment – May 2009
Issue 5.6.A
157
• with a mark IN on the start point and a mark OUT on the end point.
• with the nowline on the start point. In this case, the swap is applied up to the
end of the element where the nowline is positioned.
You can define such a swap in the Swap/Mute Configuration window accessible
when right-clicking in the audio track and selecting Add Swap/Mute.
E
XAMPLE
Initial Situation
The timeline audio configuration is 4 tracks of 2 channels. You want to play the
channels a7 and a8 (G4 track) of the source media onto the output channels a5
and a6 respectively (G3 track) of the selected part of the track.
Manual Swap Action
You will perform the swap action from a given point to another point of the G3
track. In this track, you specify which source channels will be played on the
channels of the G3 track. In this case, you will map:
• the source channel a7 to the output channel a5 and
• the source channel a8 to the output channel a6.
Result
In the general timeline display (upper screenshot below), you can see that the
swap icons on the G3 track, which means that channels are swapped on this track.
In the Swap/Mute Zoom display (lower screenshot below), you can see that the
channels a7 and a8 are played instead of a5 and a6 on track G3 from the mark IN
point to the mark OUT point.